1968-1972 Oldsmobile 442 W-30 Hurst/Olds Pontiac Tach Circuit Board

1968-1972 Oldsmobile 442 W-30 Hurst/Olds Pontiac Tach Circuit Board Round

Direct-fit replacement tachometer circuit board for 1968–1972 Oldsmobile and Pontiac vehicles equipped with factory GM tachometers that use the large round circuit board style. Ships pre-calibrated based on the information you provide when ordering.

Fitment:

• Oldsmobile: 1968–1972 models using factory GM tachometers with the large round circuit board style (including trim packages such as 442, W-30, Hurst/Olds)
• Pontiac: 1968–1972 models using factory GM tachometers with the large round circuit board style

Compatibility check: Please verify visually that your original tachometer circuit board is the large round type before ordering.

Calibration info required at order:

• Add your information: Engine, maximum RPM of gauge. (example 8cyl, 6000RPM):

Installation notes:

• After the tachometer is removed from the gauge cluster, the circuit board is typically unbolted and replaced
• You may need to solder the black and white wires from the circuit board to the meter (varies by application)
• Mounting bolts may be required depending on your application (bolts included)
• For vehicles using a points-type ignition system, a 12V jumper wire will be needed to power this upgraded tachometer circuit board (instructions included)

Connection labels: The circuit board is labeled for 12V, coil signal, and ground connections to help simplify installation.

Warranty: Lifetime warranty

Limitations: For factory GM tachometer applications only. Not a universal tachometer replacement. Verify the large round board style before purchase.

Please verify that your old tachometer circuit board is this large round type before ordering.

  **Specify Your Engine Type and Tachometer's Maximum RPM Above When Ordering. We will pre-calibrate the circuit board to match your specific application before shipping.