282 results for firebird headlight assembly

Installation tips: Prevent Paint damage: Be sure to mask area around exterior handle before removal and installation. Prior to replacement compare the replacement unit to the original. D ...

In most cases with a Pull down that does not work properly, the problem will be with the Motor/gear, Reversing Switch, or Striker Sensing Switch. Replacing these parts usually fixes the problem.Occas ...

There are several ways to test the Battery.In the real world, most Home mechanics don't have all the tools that are ideal for doing testing. For all practical purposes if the Battery has been sittin ...

Turn the ignition switch to the OFF position. Remove the RADIO fuse. Cycle the ignition switch from the OFF position to the RUN position (as far as you can go without cranking the engine) 3 times w ...

Trouble Code: P0101 MAF Sensor Signal Range/Performance/ Trouble Code Conditions: DTC P0102, P0103, P0107, P0108, P0112, P0113, P0121-P0123, P1111, P1112, P1120-P1122, P1220 and P1221 not set, engin ...

These installation tips are provided to help make installation successful. They are not intended to be complete installation instructions. Improper installation may cau ...

V8 Tachometer conversions for Vega, Camaro, Firebird, Fiero, other GM vehicle Doing a 4 cylinder or 6 cylinder engine swap to a V8? One of the challenges when doing an engine swap from a 4 or 6 ...

Note: The Rear Liftgate and Hood are heavy and awkward to hold. A falling Rear Liftgate or Hood could cause serious injuries. Two people should perform this procedure. Support Struts replacem ...

Condition 2 - Engine rotates but will not start Fuel tank empty. (This does happen surprising often.) Battery discharged (engine rotates slowly). Check the operation of electrical comp ...

Condition 1 - Engine will not rotate when attempting to start Battery terminal connections loose of corroded. Check the cable terminals at the battery; tighten cable clamp and/or clean off c ...

Improper installation may cause damage, premature failure.Please seek qualified help to install your Pull down if needed.Below you will find the "repair manual procedure" + some important installatio ...

GM Tachometers between the late 1960's and early 1990's had a common problem. They fail! How do you know the problem is the Tachometer and not the distributor or the ignition module? You can switch o ...